HUGS BABY BEANIE

Hugs Baby Beanie Project

LEVEL: EASY

WHAT YOU'LL NEED:

  • 'Bella Baby' Hugs 50g x 1 ball each Main Colour (M1) and 2nd Colour (C1)
  • 1 pair 4mm knitting needles or sizes required to give correct tension
  • Scissors, yarn needle, tape measure

MEASUREMENTS

Sizes 3-6m (6-12m)

To Fit Head 40-45cm (47-48) cm

TENSION

18 sts and 20 rows to 10cm over stocking st, using 4.50mm needles.

INSTRUCTIONS

BACK

Using 4.50mm needles and C1, cast on 65 (73) sts.

1st row (RS) - Purl

2nd row - Purl

Rep 1st and 2nd rows twice, ending with a 2nd row.

Using M1, work 4 rows stocking st.

Change to C1 work 6 rows all Purl.

Change to M1, work 4 rows stocking st.

Change to C1 work 4 rows all Purl.

Change to M1, work 4 (8) rows stocking st.

Decrease for crown in stocking st:

Next row - K6, k2tog, repeat from to end.

Next 3 rows - Knit in stocking st.

Next row - K5, k2tog, repeat from to end.

Next 3 rows - Knit in stocking st.

Next row - K4, k2tog, repeat from to end.

Next 3 rows - Knit in stocking st.

Next row - K3, k2tog, repeat from to end.

Next 3 rows - Knit in stocking st.

Next row - K2, k2tog, repeat from to end.

Cut yarn and thread through remaining sts with a needle, draw up tight and fasten.

FINISHING

DO NOT PRESS. Sew back seam and weave in all ends.

altText

BECOME A SPOTLIGHT VIP

Get VIP discounts, attend exclusive events and more