RETRO BUNTING

Instructions

Reference the downloadable project sheet for project pattern diagrams.

Step 1: Cut the Triangles

• Use your 8 1/2 inch triangle template to trace triangles onto your fabric.
• Cut two triangles per flag — one for the front and one for the back.
• Cut enough triangles for your desired bunting length (typically 6 to 8 flags per meter)

Step 2: Sew the Triangle Flags

• Place two triangles right sides together (patterned sides facing each other).
• Sew along the two long sides, using a 1/4 inch seam allowance.
• Leave the top edge open.
• Trim the point to reduce bulk, being careful not to cut through the stitching.

Step 3: Turn, Press, and Finish the Top Edge

• Turn each triangle right side out, using a point turner, chopstick, or knitting needle to gently push out the tip.
• Press each triangle flat.
• To close and neaten the raw top edge, sew across the open top using an overlocker (serger) or a zigzag stitch. This prevents fraying and secures the front and back pieces together neatly.

Step 4: Arrange and Sew to Flat Cotton Tape

• Lay out the triangles in your preferred order.
• Position the top back side of each triangle against the back of the cotton tape, so the tape runs along the front top edge of the triangles when viewed from the front.
• Space the triangles evenly — about 2 inches apart, or closer if you want a fuller look.
• Pin or clip each triangle in place.
• Using a straight stitch, sew a single line across the top edge of each triangle, attaching it securely to the tape.

Step 5: Final Press & Hang

• Give the whole bunting a final press to make it neat and crisp.
• Hang and enjoy your handmade decoration!