|Your browser is not supported.|
Please browse our site using any of the following options:
WHAT YOU'LL NEED:
- Plain headband base
- 2m of Velvet trim ribbon
- Pearl beads
- Hand sewing needle and thread
- Worn with additional Padded Velvet Headband
- Hot glue gun and glue sticks
Step 1 - Use the needle and thread to sew the Pearl Beads onto the plain headband base, evenly positioning them so there is roughly 1cm between them. Stop the beads roughly 5cm from the ends of the headband so it can sit comfortably behind your ears.
Step 2 - Once all the beads are attached, it's time to wrap the velvet ribbon. Start at one end and secure the end of the ribbon to the headband with a little hot glue or hand stitch in place. Then continue to wrap the ribbon around the headband and between each Pearl bead. Continue until the whole headband is covered, and again secure the end of the ribbon neatly at the other end with glue or stitching.
Step 3 - To finish, match with the Padded headband and your look is now complete!