|Your browser is not supported.|
Please browse our site using any of the following options:
3D EASTER EGG HAMA BEADS
WHAT YOU'LL NEED:
- Hama Large Circle Pegboard
- Hama Beads
- Baking paper
Step 1 - You will use the large circle pegboard for your projects. Follow the templates to create your egg designs.
Step 2 - Ask an adult to fuse your designs. Place your pegboard on a flat, heat-safe surface. Set a household iron to the medium setting. Place ironing paper over the pegboard. In a circular motion, begin to iron the project. When ironed properly, the beads will still have open centres. DO NOT OVER-IRON as this will cause the beads to close and can make assembly of your project more challenging. Let the design cool.
Step 3 - Remove the paper and bead design from the pegboard. Flip the design over to expose the non-fused side. Repeat step two. Let cool completely. Once the design is cool, peel off the ironing paper. Your pegboards and ironing paper are reusable. Note: Beads need heat for about 10-20 seconds per side to fuse evenly. Lift the paper occasionally to see how the beads are fusing. Additional heating time may be required.
Step 4 - Assembly: Slide the feet evenly parted onto the eggs lower edge.