WHAT YOU'LL NEED
- Mountain Wreath
- Selection of decorative Flower heads/bunches Selection of florist leaves *Choose flowers and leaves to a theme of similar colour
- Crystal Stones Chips Crystal Pendants
- Crystal Agate
- Chain length
- Jump Rings
Step 1 - Wrap twine around half of the wreath, overlapping and crossing over in the middle . Knot some of the cross overs or cut lengths to connect different strands to create a half web. Also cut a length and tie around the top of the wreath into a loop for hanging.
Step 2 - Pull apart the florist leaves from their bunches to individual strands. Using the wire stem, insert the leaves around the edges of the wreath *Only cover 2/3, make a crescent moon shape. Overlap leaves to create density. Wrap the wire around the wreath/twigs to secure in-place.
Step 3 - Lay out your pattern of decorative flowers in the center of the wreath, cover the leaves slightly but not too much to block them out. Once you are satisfied with the placement and quantity of flowers, glue the into place (use either E6000 or hot glue gun). *Some flowers have stems, you can use these similar to the leaves and wrap around the wreath to secure or cut the them and glue in place. Add any extra embellishments you wish within the flowers for extra decorations.
Step 4 - Also glue crystal stone chips on top of the twine web in the middle of the wreath. This will act now as a dream catcher.
Step 5 - Cut one lengths of chain and wrap through an crystal agate hole and then connect back to the chain length with a jump ring to secure the crystal. On the other end attach a crystal pendant with a jump ring.
Step 6 - Attach the chain length in two places on the bottom of the wreath - one side, using jump rings. Space the two crystals away from each other and allow excess chain to hang in between to form a dangle. Play with the drop of the crystals with adjusting the length of chain given to each side.
Step 7 - Repeat Steps 6-7 and to create another crystal hanging on the opposite side.