FOLK ART ETCHING CREAM DOG TREAT JAR

Instructions

Step 1

• Prep the surface with a tablecloth or similar covering.
• Wash the glass jar with warm soapy water. Allow to dry completely before starting project.

Step 2

• Prepare your template. We used a machine to print and cut our template on adhesive vinyl.
• If you don't have a machine, you can print or draw your design and transfer to a similar material.

Step 3

• Either use the adhesive back and place your template directly onto the glass. If template is not adhesive, use tape and secure the edges so the template does not move.
• Ensure the template has adhered well (we used a brayer to roll out bubbles). Any edges of the template that is not stuck down may cause bleeding of the design.

Step 4

• Wear protective gloves to avoid skin contact.
• Use a brush and apply a thick, even layer of the cream over your stencil or desired design, ensuring all exposed areas are covered.
• Ensure the cream covers the entire design.
• Let it sit for about 15 minutes, rinse the cream off under running water, and dry the surface.
• Rinse the sink with running water for at least two minutes to wash away any remaining cream

Step 5

• Remove the stencil or tape to reveal the etched design.
• Dry the surface completely.
• The design is now permanent and dishwasher safe.