![]() | ||
| Your browser is not supported. | ||
|
Please browse our site using any of the following options:
| ||
BRIGHTON COTTON FILET CARDIGAN
Level: Advanced
What you'll need:
- 9 x 4 Seasons Brighton Cotton Blend 50g Balls
- 6 x 8-10mm buttons
- 5mm crochet hook
- Scissors, ruler, yarn needle, cotton thread
Measurements
Approx 96cm chest x 44cm long
Tension
Open mesh: 9 squares wide x 10 squares high to 10cm
Instructions
Reference the downloadable project sheet for project pattern diagrams.
Special Stitches / Abbreviations
Tr2tog: treble 2sts together - yoh, insert hook in specified st, yoh and pull through, yoh and pull through 2 loops on hook, yoh and insert hook in next specified st, yoh and pull through, (yoh, pull through 2 loops on hook) three times.
Note: Cardigan is worked from the lower edge in one piece, following the graph. Shoulders are stitched together, then sleeves are crocheted (following a graph) and sewn on. Collar is crocheted around the neck opening, following a graph and finally, the edging is crocheted on.
Filet crochet is a combination of open and filled squares to form an image. The open squares consist of tr with 2ch between each tr. The filled squares have the ch replaced by tr.
Beg Cardigan -
Using 3.5mm hook, make 243ch.
1st Row - Miss 3ch (counts as tr), 1tr in each ch to end ... 241tr.
2nd Row - 3ch (counts as tr throughout), 1tr in each of next 3sts, * 2ch, miss 2sts, 1tr in next st, rep from * to last 3sts, 1tr in each of last 3sts.
These two rows are the first two rows in Diagram 1. Cont from 3rd Row in Diagram 1 to complete body of Cardigan, dividing the fronts from the back to make sleeve holes as shown, and working tr2tog to decrease at neck edge as shown.
Fasten off, leaving tails for sewing.
Sew shoulder fronts to back, matching mesh holes.
Sleeves (make 2) -
Using 3.5mm hook, make 35ch.
1st Row - Miss 7ch, 1tr in next ch, cont to work from 1st Row of Diagram 2 to make Sleeve, starting each new row with 5ch (counts as 1tr, 2ch).
Fasten off, leaving a tail for sewing.
Sew sleeve seams, then position sleeves in sleeve holes with seams at the bottom and matching mesh holes.
Join yarn to Sleeve seam at lower edge and using 3.5mm hook, work 1tr in Sleeve seam and each st and sp around, slst into tr at beg.
Fasten off.
Collar -
Join yarn to 4th tr of edge of right front and using 3.5mm hook, work 1tr in every st, 1tr in each shoulder seam and 2tr in every sp to corresponding tr on left front, turn ... 115tr.
Follow Diagram 3 to complete Collar.
Fasten off.
Scallop Edging -
Join yarn to 1st tr of top left front and using 3.5mm hook to work along left front, * 7tr around post of edge tr in next row, slst between trs of next and foll row, rep from * to last row, rotate to work along bottom edge, work 1tr at base of each tr across to right front, rotate to work up right front to correspond with left front.
Fasten off.
Finishing
DO NOT PRESS. Sew in ends. Sew buttons on left front along tr strip and in line with the centre of 1st, 3rd, 5th, 7th, 9th and 11th scallops (buttonholes are the centres of the corresponding scallops on right front).
