DIY KIDS WOLF MASK

Instructions

Reference the downloadable project sheet for project pattern diagrams.

1. Trace Appliqu Pieces
   - Using your wolf mask pattern, trace the appliqu details (snout, inner ears, nose, etc.) onto the paper side of the Heat n Bond.
   - Cut loosely around each traced shape.
2. Iron Heat n Bond to Fabric
   - Iron the adhesive side of each Heat n Bond piece onto the wrong side of your chosen fabric scraps.
   - Let them cool, then cut out the fabric shapes exactly on the lines.
   - Peel off the paper backing.
3. Create the Front Mask Panel
   - Cut the front mask base (grey fur cotton) using the full mask shape, including eye holes.
   - Arrange your appliqu pieces on the front panel.
   - Once you are happy with the layout, iron them down to fuse.
4. Top-Stitch the Appliqu
   - Use a straight stitch (1/8" from edge) to top-stitch around each appliqu shape.
   - This secures them in place and adds a finished, decorative outline.
5. Cut the Back Mask Panel
   - Cut an identical shape for the back of the mask, including eye holes.
   - This will be stitched directly onto the back of the front panel.
6. Add the Elastic Strap
   - Cut a piece of thin elastic (10-12", adjust for fit).
   - Position each end at the sides of the back panel, with the elastic ends facing inward (it will get caught between layers when stitched).
   - Pin or baste in place.
7. Assemble the Mask
   - Lay the back panel flat against the wrong side of the front panel, sandwiching the elastic ends between the two layers.
   - Align all edges and eye holes.
8. Sew the Mask Together
   Stitch around the entire outer edge and eye holes using a 1/8" straight stitch, securing the front and back together.