JUST BEAD IT BRACELET AND EARRINGS

INSTRUCTIONS

Steps for bracelet

Step 1 - Using the large bracelet memory wire cut a piece that allows the wire to go around the wrist 3 times. Add another length that is half the size of the wrist again so there is overlap to work with.

Step 2 - Create a loop at one end of the memory wire. In this way no beads will come off the wire as they are threaded.

Step 3 - Thread one full circle with gold seed beads, one full circle with gold round beads and one full circle with green seed beads.

Step 4 - Check that the beads create a full circle around the wrist for each bead type.

Step 5 - Trim the end of the memory wire so that there is enough length to turn a loop at the end.

Step 6 - Add charms or tassels to the loops if desired.

Steps for earrings

Step 1 - Using the ring bracelet memory wire cut a piece that has a full circle plus a little extra to allow loops to be turned at each end.

Step 2 - Turn a loop at one end.

Step 3 - Thread on one gold seed bead, one green seed bead, one gold round, one green seed bead and one gold seed bead.

Step 4 - Turn a loop at the other end.

PINK AND CRYSTAL SET

WHAT YOU'LL NEED

• Beadalon Memory Wire Variety Pack (silver or gold)
• Just Bead It Multi-Strand: JBP603
• Just Bead It White Magnesite Strand: JBNS50
• Just Bead It Wire Wrapped Crystals: JBC16
• 2 shepherd hooks (silver or gold)
• 3 head pins (silver or gold)
• Memory Wire Cutters
• Wire Looping Pliers

INSTRUCTIONS

Steps for bracelet

Step 1 - Using the large bracelet memory wire cut a piece that allows the wire to go around the wrist 5 times. Add another length that is half the size of the wrist again so there is overlap to work with.

Step 2 - Create a loop at one end of the memory wire. In this way no beads will come off the wire as they are threaded.

Step 3 - Thread one full circle with small pink seed beads, one full circle with clear crystals, one full circle with alternating pink cube and small seed beads, one full circle with white magnesite beads and lastly a circle with small pink seed beads.

Step 4 - Check that the beads create a full circle around the wrist for each bead type.

Step 5 - Trim the end of the memory wire so that there is enough length to turn a loop at the end.

Step 6 - Add wire wrapped crystals to each loop to finish.

Steps for earrings

Step 1 - Thread onto a headpin: 1 pink seed bead, 1 large crystal, 1 pink seed bead, 1 white magnesite bead, 1 pink seed bead.

Step 2 - Add an 8mm round bead, cut the head pin at the end of this bead. Remove the bead.

Step 3 - Turn a loop at the end of the head pin.

Step 4 - Add a shepherd hook.

Step 5 - Repeat steps 1-4 for second earring.