IMPRESSART MANDALA BRACELET
WHAT YOU'LL NEED:
- Large Steel Stamping Block
- ImpressArt Stamping Hammer
- Mandala Design Stamp Pack 4
- 5/8 Bracelet Blank
- ImpressArt Enamel Marker
- Bracelet Bending Tool
- Bracelet Bending Plier
Step 1. Lay your bracelet blank flat and start at the center middle line.
Step 2. Place the *stamp on the middle line and continue the pattern vertically and horizontally.
Step 3. Place the *stamp on top of the *stamps. Continue the pattern around the cuff.
Step 4. Stamp the *pattern between the *pattern and *stamp. Continue the pattern around the cuff.
Step 5. Stamp the *pattern at the end of both *patternand *stamp. Continue the pattern around the cuff.
Step 6. Stamp the *pattern in between existing pattern. Continue the pattern around the cuff.
Step 7. Repeat steps 1-6 across the bracelet cuff.
Step 8. Use the bracelet bending bar to round bracelet cuff. Place one end of your bracelet inside the channel and hold firmly with your thumb. Bend your bracelet half way using the palm of your hand. Insert opposite end and repeat.
Step 9. Use bracelet bending pliers to round bracelet cuff. Begin in the center of your cuff and squeeze down. Work your plier around your bracelet cuff giving it a rounded finish.
*View all required patterns and stamps in the downloadable project sheet.