NO SEW WIRE HAIR WRAP

INSTRUCTIONS

Step 1 - Cut the fabric into a piece 6" by 32" long. Fold this piece in half length ways and trim the end on an angle.

Step 2 - Open the fabric and fold in a seam allowance of about 1/2" and pin into place then press with an iron and remove the pins.

Step 3 - Place fabric glue along the seam allowance and fold the fabric in half to glue the edges together. Ensure to leave one of the short ends open so you can insert the wire later.

Step 4 - Leave the fabric to dry while you prep the wire. Cut a piece of wire approximately 36" long and create a loop at each end by wrapping the wire back on itself about 2" in from each end.

Step 5 - Use a scrap piece of fabric to cover the wire so it is padded inside the headband. Do this by wrapping the scrap piece of
fabric around the wire and glue or tie the ends to secure.

Step 6 - Now insert the wire into the end you left open in step 3. Once the wire is in glue the end shut ensuring that the ends line
up neatly.

Step 7 - Once the glue is completely dry your head band is ready to be worn! Enjoy.